A Guide To Laying Karndean Flooring by Derek Rogers

Karndean flooring is fully synthetic vinyl flooring that comes in tile and plank sizes not sheets as other traditional varieties of vinyl do.



It will come in a variety of designs that mimic perfectly other traditional floor finishes such as timber, stone, and slate. This type is an ideal solution for those who want to use a selected floor finish in the area the location where the actual product will be unsuitable such as a timber floor in a very bathroom as an example.



It is very versatile as possible laid over everything floor surfaces, wood, tile, asphalt, concrete even existing vinyl. Pdf files are for sale to download that can advise you for the correct preparation of your respective floor (many of the useful for unusual subfloor materials such as asphalt and then for new concrete floors that will still have high moisture content.)



This guide will discuss the principals involved in laying Karndean flooring over a subfloor of aged concrete, wood, vinyl etc. If you are going to lay your Karndean flooring with a more unusual subfloor it really is highly advisable that you just consult helpful tips for the specific preparation and adhesive requirements of your respective subfloor.



Laying this particular flooring is a reasonably easy operation that is well within the ability of the typical DIY person. As with any flooring installation, the right preparation in the sub floor is vital. You must make sure that your floor is clean, flat and level understanding that there are no lumps, bumps, and grit or sharp objects. Anything that is on the subfloor will show under the Karndean flooring and will cause damage. Floors which are uneven will be highlighted by light entering through doors or windows.



Firstly prepare your subfloor, for kitchens Peabody MA timber floors it is advisable to put plywood sheeting which is well fixed towards the timber floor and possesses the joints filled with a fine finishing compound, concrete floors may have plywood sheeting laid and secured for them or a superb screed can be applied to give a flat surface. (The screed will not totally level the top however.)



Before you commence to get the Karndean tiles or planks permit them to acclimatise towards the room for around 24 hours. Unpack the flooring and leave to sit in the room - this may avoid the planks or tiles expanding or contracting once they have been laid.



Karndean supply many different adhesives to suit the different subfloor materials, choose the right adhesive to your subfloor. Spread the adhesive on top of the floor with all the trowel that comes attached on the adhesive container. Ensure which you spread the adhesive on the manageable area in order that it does not set off before you are actually able to put your tiles or planks.



Once you've laid the flooring roll and cross roll the complete floor using a 100lb roller. Check again into two to 3 hours and reroll if necessary (or if recommended on the adhesive container.) Do not walk on, wash or polish the floor for your amount of time recommended for the adhesive you used.



Kardean flooring can be a solution that gives you the look of timber, stone or any other flooring materials but that won't warp, chip or perhaps be affected by heat and humidity because natural products may.





Derek Rogers can be a freelance writer who represents many UK businesses. For vinyl flooring, he recommends Completely Flooring, one in the UK's leading suppliers of Karndean Flooring: