利用者:Aemair7406

If some testing is great, then extra testing should be far better, so we contacted as a lot of coldair, high-flow consumption makers as we could to get our testing to the up coming degree.

For the J” Cold Air check, we proceeded to duplicate the identical test procedure as the Steeda CAI was put by means of. Typical coolant temp was 192.28. At the start off of the test air charge temp had risen to a max of 122.00. - a net of seven.two degrees hotter than our Steeda ProFlow CAI Automobile speed was brought up to 45mph and the incoming air temperature dropped to a minimal level of 96.eight degrees in 54 seconds. Also, a 25.2 degree drop, but still 7.2 degrees hotter than the Steeda ProFlow consumption , and 13.8 degrees over ambient temperature.

It is linear piping, the total intake is absolutely sealed off from the engine bay from the OEM air inlet to the throttle physique/turbos (based on application), no exposed filter. We use carbon fiber piping and carbon fiber heat shielding, also we utilized OEM mounting factors and the air inlet with our personal developed intake scoop. Verses a common air intake (Air Raid) we noticed large gains on a car with downpipes and catback, 10.6whp and 16wtq to be precise.